Unfinished steel sailing yacht made according to the plan of Bruce Roberts. A very firm, steel hull and superstructure is made from the sheets of thickness 4mm, 5mm and 6 mm. The construction (welding) was done under supervision of the LLyod.
Dimensions of the hull: L=14,99m, W=4,45m, draft=2,08m
The hull is extended by stainless bowspit 1,25 m, which makes LOA 16,25 m. The edges of the board of whole yacht are protected by welded stainless circular rod, discharge pipes for the outflow of the water from both cockpits are made also from the stailess steel.
The ruder is increased for higher effeciency. The rudder is semibalanced and fixed to the skeg. It consist of complete bearings, shaft, Coker pipe, fixed piston rod of hydraulic stearing.
There is a complete preparation (frames) made from steel L-profiles for the construction of cabins, beds, benches, kitchen cabine, shelves etc. The plywood plates are missing.
There are ready basements for engine, water tanks, waste water tank, diessel tanks, bateries,2 shower basins and 2 washbasins.
There are already mounted supports of both masts (ketch) – 2 very strong second hand masts (18 m and 12 m) including wires, but the masts need to be completed, a new main sail and second hand rollfock.There is another complete 22 m mast and 4,9 m boom which is not included in this offer but available at fraction of the price.
The motor (not fixed yet but basement is ready) is Nanni Diessel 5,250 TDI with reverse ZP 25M 2,27. Steven shaft and propeler are not available.
There are 8 pcs of order made winches 68″ The number can be increased up to 11 pcs also at the fraction of the price.
There are 2 pcs of stoppers, traveller system (railways, travellers, etc., and some portholes , possition lights, electric switchboard, water boiler, drink water pressure tank with pump, 7 pcs of stainless tanks (5 x about 300 l, 2 x about 150 l), refrigerator cooling equipments, 2 x electric WC, VHF radio, dorades, shortly used bow-thruster, the tube is already mounted to the hull,
There is a special jig for the transportation on the truck. The jig is cut appart but can to assembled again.