Remarks :
Beneteau 361 Clipper for sale in Kent:
This 2000 Beneteau 361 Clipper is a cruising yacht with good sailing performance.The boat has a white GRP hull with a white superstructure and decks with non-slip surfaces, stainless steel stanchions, a pulpit, and a self-draining cockpit.
The B&G navigation equipment includes a 2021 Depth Gauge, a 2021 Speed/Log, a 2023 Windspeed/Direction, a 2021 fixed VHF Radio, and a Vulcon 7 chart plotter.
The yacht was last out of the water in May 2025 to check and clean the copper coating, hull polish, and anodes replacement. The vessel also benefits from some service history, a new cutlass and an inboard shaft bearing were fitted in 2018.
The current owner has enjoyed the vessel for the last 5 years and is looking to move away from sail and move across to motor. This vessel has had only three previous owners.
Please call our Kent – Office +44 (0)1634 571605 for further information or to arrange a viewing.

Accommodation :
This Beneteau 361 Clipper provides 8 berths in 3 cabins, with a maximum headroom of approximately six feet. The forward cabin features a double berth with shelf storage to both port and starboard, along with a hanging locker to starboard. This cabin also benefits from an opening deck hatch.
The main saloon features a centre table with booth-style seating to starboard and a single settee to port. Behind the backrests, you’ll find shelves and lockers for additional storage, with more space available beneath the seating. This area also converts into a double berth or two singles, depending on your needs.
Located on the port side of the saloon is the chart table, with internal chart storage and instrumentation including the B&G VHF, the vessel distribution panel, and JBC radar.
Aft of the chart table on the port side, within the saloon, is the galley, equipped with a gimbaled 2-burner gas hob with oven and grill, a double stainless-steel sink with pressurised hot and cold water, a 12V fridge, and ample storage space. This vessel also benefits from a 360-litre freshwater capacity tank. Water is heated by the engine and a 240V immersion heater.
Opposite the galley is the heads compartment, with a marine toilet connected to a 2020 45-litre holding tank, a washbasin with hot and cold water, and a shower with an integrated shower tray.
Located at the stern of the saloon, behind the galley and the heads compartment, are two rear cabins to both port and starboard, each featuring a double berth and a practical standing area for dressing.
These cabins also offer a variety of storage options, including shelving, hanging lockers, and additional under-berth lockers for added convenience.
The companionway steps lead to the aft cockpit, featuring bench seating for up to eight people and generous storage. The central cockpit binnacle instrumentation includes a B&G compass, a 2023 B&G wind direction indicator, a B&G Vulcan 7 chart plotter, a 2021 B&G speed log, engine controls, and helm.

Inventory :
Deck Equipment:
Anchor – with 50 metres of chain and warp
Anchir windlass – Electric
Mainsail cover
Sprayhood
Cockpit canopy enclosure
Cockpit dodgers
Bathing platform
Boarding ladder
8 x Fenders
8 x Mooring warps
Navigation Equipment:
Compass – B&G
Depth Gauge – B&G, 2021
Speed/Log – B&G, 2021
Windspeed/Direction – B&G, 2023
VHF Radio – B&G, 2021
Chart plotter – B&G – Vulcon 7
AIS Receiver
Stand Alone Radar – JBC
Auto Pilot – B&G
Electronic Charts
Navigation Lights – Mast and Deck Level
Paper Charts – Some
Clock and Barometer
Safety Equipment:
2 x Fire extinguishers
Fire blanket
1 x Horseshoe lifebuoy with floating light
Danbuoy
Emergency Tiller
1 x Manual bilge pumps
1 x Electric bilge pump
Radar Reflector
Keel:

Fin keel with tiller steering

History and Construction:

This Beneteau 361 Clipper was built in 2000 by Beneteau to a Beret/Racoupeau design. The boat has a white GRP hull with a white superstructure and decks with non-slip surfaces, with stainless steel stanchions, a stainless-steel pulpit, a fin keel with a spade rudder and a self-draining cockpit.
The yacht was last out of the water in May 2025 to check and clean the copper coating, hull polish, and anode replacement. The current owner has enjoyed the vessel for the last 5 years and is looking to move away from sail and move across to motor. This vessel has had three previous owners.

Title Documents:
When preparing these details, we have seen the following documentation:
Bill of Sale in the owner’s name.
Previous Bills of Sale.
Declaration of Conformity to Recreational Craft Directive.
Invoice showing VAT has been paid at the time of purchase.
Proof of location on 31st December 2020.
Owner’s manual
Marine Insurance:
As one the UK’s largest Brokers with over 700 boats for sale we are able to introduce you to Boat Insurance providers that offer all types of Boat Insurance including insurance for Yachts, Sailing Boats, Motor Cruisers, Narrowboats, Inland Waterway Craft, Barges, Houseboats, Speedboats, Rigid Inflatable Boats, Waterski Boats, Jet Skis, Personal Watercraft and Dinghies.
Just click on the following link to request an insurance quote for this boat or your current boat: (website in contact data)/

Mechanical :
Sails and Spars:
This Beneteau 361 Clipper has a Bermudan Masthead Sloop rig, with a deck-stepped Aluminium mast and boom, with stainless steel standing rigging. Equipped with a furling headsail, a slab reef, mainsail and Lazy Jacks. The stainless-steel standing rigging was replaced in 2018, and the running rigging was replaced in 2023/2024. This vessel also includes an aluminium spinnaker pole.
Winches:
2 x Sheet winches, Lewmar, self-tailing
2 x Halyard winches, Lewmar, self-tailing
Sails:
Mainsail, new in 2000, condition good, last valeted 2023
Genoa, new in 2009, condition good, last valeted 2023 with a new UV strip in 2021.
Mechanical Systems:
This Beneteau 361 Clipper is equipped with a year 2000, Volvo 2003 diesel engine with 28HP, 3-cylinder, indirectly cooled with Morse controls. The engine hours are unknown.
This Volvo engine is powering a shaft-driven 3-bladed folding propeller and is supplied by a 75-litre plastic fuel tank. The engine was last serviced in 2024; this vessel should achieve a cruising speed of approximately 6 knots and a maximum speed of 7.5 knots. The vessel also benefits from some service history, a new cutlass and an inboard shaft bearing in 2018.

Electrical Systems:
This vessel is equipped with 3 x 12v batteries. (2 x 110 AH domestic battery replaced in 2024, & 1 x 75AH engine start battery replaced in 2024.) These batteries are all charged by the engine alternator and via a 240v battery charger.
This Beneteau 361 Clipper is also benefits from a 240-volt shore power, with outlets throughout the vessel, along with a 240-volt immersion heater and a 240V battery charger.